Vehicle & Technical > Defender

PanHard Rod Bolts

(1/3) > >>

drum:
Anybody know what size bolt should hold the PanHard Arm??

I've just rebushed in and the holes aren't big enough in the new bushes!! Guess who butchered the old ones getting them out  :(

Paul:
Upto (V)2A626645    M14x80
From (V)2A626646   M16x82

drum:
I've destroyed the old bushes getting them out, and I think the ones I've put in are M14 holes, and the ones I've destroyed are M16, and what the odds of me finding the right ones the day before Christmas locally?? Sweet FA.

Do you reckon I can drill a polybush?? If so I can put the old steel tubes into the new polybushes?? At least as a temporary solution.

BTW Thanks for the quick response Paul.

Paul:
Get on the phone tomorrow and have a ring round.

Don't bodge it. :shock:

Bush should be: RYG101460 (But check it)

Good luck.

drum:

--- Quote from: "Paul" ---Get on the phone tomorrow and have a ring round.

Don't bodge it. :shock:

Bush should be: RYG101460 (But check it)

Good luck.
--- End quote ---


Thanks Paul, I took them out as part of the sorting front end, and poly bush it while i'm there. It was meant to be a relatively simple job just take a couple of hours this afternoon. So much for that. Obviously my preference to get some Polybushes that are the right size, failing that get some normal ones.

And if that fails then I might have to drill the polybushes just for over the Xmas period.  :(

Navigation

[0] Message Index

[#] Next page