Vehicle & Technical > Series Land Rovers

Anybody know the head bolts torque settings

(1/2) > >>

Miniman:
Anybody know the head bolts torque settings for a series 3 2.25L Diesel engine?

Sharpshooter:
Usually about 15 ftlb's
then 90 degrees
and another 90 degrees.

But some may say different.

Andy the Landy:
90lb.ft for the 1/2in. UNF bolts (head bolts)

18lb.ft for the 5/16in. UNF bolts (rocker shaft)

Make sure the sequence is correct and dont put all the pressure on at once :wink:

Canada Al:
90 ft/lbs for head bolts is spot on by the book ....Al

James.Harwood:
RTFM - don't even think about trying head work without the manual, if you torque up or release the head bolts out of sequence you risk knackering your head.

Navigation

[0] Message Index

[#] Next page