Vehicle & Technical > Defender

QT Radius Arms

<< < (4/6) > >>

drum:

--- Quote from: "Henry Webster" ---I go for subtlty everytime.  8)
--- End quote ---


Says the man in the Cow Pattern Disco  :lol:  :lol:

turtle:
Big and Bold......



RED :)

Sharpshooter:

--- Quote from: "drum" ---After thinking about this all day, I've just been under the Defender, and measured both sides accurately. And can confirm that the Radius Arm on the Passenger Side is 5mm closer to the chassis than on the Drivers Side!!!

Now the important question isn't why, or how, but now that I've got to paint them after modification, do I paint them subtle black, or "Hey Look I've Modified It Red"??
--- End quote ---


Have you checked your panhard rod bushes. This could be something to do with it not lining up properly??

drum:
I've not examined them indetail, but they didn't strike me as stuffed in anyway when I spent all day under there on Saturday, could they really move the front axle over by that much?? Mind you if there is a 5mm difference I suppose that's only 2.5mm out. I think I've got the polybush ones here to replace them, so I'll replace them before I grind anything just incase, but I think it's still going to be a grind to fit job, maybe just not quite so much.

Paul:
Don't forget to swap the large washer over to the new arms. :wink:

I know someone who fitted new qt arms and didn't swap the large washer over. :lol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page