Vehicle & Technical > Discovery

Fitting DEVON fender flares ?

(1/2) > >>

Dridze:
Hi,

How long wil it take to fit these, i have a 2 door Disco so no cutting the rear doors :D, anyone done this mod :?:
thanx

grtz Hans Hoekstra

ps i'm having it done because i don't have the time and place :(

muddyweb:
Depends on how good the bodyworker is.   Allow a day for it to be done properly.

Bulli:
if you can borrow a "nibbler" its a doddle. I fitted mine in about 2 hours, they are still there ,err i think.
Just remember measure twice cut once and you will be ok. The nibbler takes a lot of hassle out of the job being slower and far more controlable than a jig / air saw. plus it cant hit anything behind!

chuggaman:

--- Quote from: "Bulli" ---if you can borrow a "nibbler" its a doddle. I fitted mine in about 2 hours, they are still there ,err i think.
Just remember measure twice cut once and you will be ok. The nibbler takes a lot of hassle out of the job being slower and far more controlable than a jig / air saw. plus it cant hit anything behind!
--- End quote ---


i agree

expect to be cutting this much away

mike

Budgie:
Using a jigsaw I think it took about 2 hours to do the first one and 45 minute for the last. That was cutting the wing, shaping the flare to fit and installing it.

On the front you have to remove the plastic inner wheelarch, this is rivited to the inside of the wing!

Here's a couple of photos of mine during the fitting:

Navigation

[0] Message Index

[#] Next page