Vehicle & Technical > Series Land Rovers

Blind

(1/5) > >>

rustprooflandyracer:
Not literally, Really need to get a work light on the rear, however the only way I can see you are able to fit it is via drilling into the rear roof section. Not overly keen on doing this so is there another possible way of attaching it to the rear?

Also I found the best solution to steaming up windows by rubbing fairy liquid onto them, the steam just rolls off it, Just a small amount required otherwise it goes blurry and now it smells 'lemony fresh'  :D

Any way the main post is about fitting a rear work light... so suggestions appreciated  :?:

Matt

Jim-Willy:
I drilled a hole, ya gotta drill holes to fasten it on anyway.  i use 3 out of the four screws to fasten the light on and the other hole put the wire through with a bit of dum dum to seal the hole.  Also dont buy a work lamp they are a rip off, go to a tractor/agricultural shop and buy a tractor plowing lamp they are only a few quid and are very very bright.

Paul:
I've seen a couple of people that have used CB antenna gutter mounts.

spy:
I drilled a hole 2.  Mine came with one big bolt so I had to drill a big hole for that and another small one for the wire.  

I hate drilling my landy, its scary!   I nearly had a nervous breakdown with the snorkel! ;):D

jimthelandyman:
I drilled mine too, don't really want to drill now though with my new paint job. I used a wire gromit to put the wire through and keeps it watertight.

Navigation

[0] Message Index

[#] Next page