Vehicle & Technical > Discovery

Disco Front Recovery Eyes.

(1/2) > >>

blacknight:
I would like more heavier duty recovery eyes at the front of my Disco 300 Tdi than the original ones. Does anybody know if it's possible to fit jate rings or a steering guard with towing eyes and still keep the plastic spoiler below the bumper.

Any ideas or does this plastic spoiler have to be removed.

Colin 009:
Can be done,  :D  streering guard with towing rings and Hi-lift jacking points, just need to trim the valance a bit.

Jake:
You can fit jate rings but depending on the direction of the recovery they will snag the front valance.
If your stuck back end in a hole they will be fine.
if the front is dug in then the rope will pull upwards.
Could you not remove the lower valance?
Its easyly done.
 :D

DISCO-CHRIS:
can indeed be done! i had standard bumper on mine along with steering guard that incorporated recovery eyes.(still got bumper if you don,t wanna cut yours?)just had to cut out slot in valance a bit. :wink:

s.stirley:
Yep, ditto. I got the guard from Paddocks, for 75 quid (plus the dreaded) it's a real solid piece of kit. Didn't take long to fit, and I just ripped the valance off and cut the end-caps down with a jigsaw :) It's done some fairly hard work since then and still looks good as new. Highly recommended.

Cheers

Navigation

[0] Message Index

[#] Next page