Vehicle & Technical > Defender

cross member on 90

(1/1)

timberdog:
A mate of mine has asked if i can sort the welding on the rear crossmember on his 90.

Can you buy new crossmembers?
How do you remove the old one?

Xtremeteam:
you can buy one from any of the parts suppliers in the mags & my fav way of removal is the gas axe,if not a 9inch grinder helps,there was a discussion here not long ago bout rear X members

muddyweb:
When cutting, be very careful not to slice through the wiring loom which runs down the chassis rail inside... you won't be happy ;-)

To weld the new one back on, I cut a couple of holes in the rear floor above the chassis joint so I can weld from the top and make a better job, then just put some nice plates back over the holes.

Navigation

[0] Message Index