Vehicle & Technical > Discovery
diffs and lockers
chuggaman:
so this is the rear
http://www.ashcroft-transmissions.co.uk/upload/large_174.jpg
and this is the front
http://www.ashcroft-transmissions.co.uk/upload/large_400.jpg
mike
Bulli:
yours is a 200 isnt it? You will have 10 spline like mine were. 24 spline are stronger(here comes another debate) because the stresses are spread over a much larger surface area.
Unless you buy heavy duty from ashcroft or someone and they have made them as a replacement you may find I was right and the halfshafts are too long!!! (did warn you) In which case you need to change the stub axle and the entire fronts....may be better buying complete 24 spline front set up...its the way i did it.
chuggaman:
dint think these will be on by the weekend then!
mike
Bulli:
i was bolting the drive flanges when i discovered the horrible truth!!i thought hang on the bolts are too long there is still a gap!
chuggaman:
think ill make some calls tomorrow
mike
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version