Chat & Social > The Bar - General Chat

Damp Petrol Electrics

(1/2) > >>

MTyrrell:
Dose anyone have any suggestions as how to go about drying out ford electrics.

 We have had heavy rain here all day, on my way in to work the road was fluded so i slowed right down and went through, as i got about halfway through some t**t in a 7.5t flatbed came belting through and swamped me. Came quite high because the fan belt started to squeal.
 It ran fine for the quarter mile till i got on site, was steaming a bit when i parked up.
 Left it for four hours now it won't start, turns over but wont kick in to life. car abandoned, got a lift home.

 If only i had finished the TDi conversion on the Land Rover Now totaly peeved off :(

dave_2A_2.25Turbo:
You don't say what Ford, but the answer is WD40, lots and lots of WD40.

Don't forget the inside of the dizzy (not just the cap) if it has one

waveydavey:
WD40 is pretty damn good but if you can get it a solvent based electrical cleaner is even better as it doesn't collect dirt afterwards.

muddyweb:
A good clean rag tends to work quite well too ;-)

Bishops Finger:
rags WD 40 heat etc

Navigation

[0] Message Index

[#] Next page

Go to full version