Vehicle & Technical > Discovery

Cones

(1/18) > >>

Dave:
Has any one got pics of how dislocating cones fit. How they sit inside the spring and on the top. Basically how they are held in place. Cheers.

Littledan:
dave,

the cones sit in the top ring, the cone sits below it and there is a big washer sorta thing and then there is a bolt that goes through the washer and in the middle of the cone

like pic below

hope it helps :D

Dave:
Thanks Dan i just carn't get my head around why the cone will not go up. I take it that the bottom of the spring holder is smaller than the cone

Littledan:

--- Quote from: "Dave" ---Thanks Dan i just carn't get my head around why the cone will not go up. I take it that the bottom of the spring holder is smaller than the cone
--- End quote ---


no problem mate.

the spring slips over the cone so the cone is held in one place by the bolt the cone is smaller that the spring so the spring can move smoothly on and off the cone,

if u send me a PM i will post some pics i have just took of dads so u get a better idea :D

dan

discodj:
Hi dave its Derrick at lrs 110 springs have a bigger internal diameter so the rear cones are of diffrent sizes make sure you have the correct ones

Navigation

[0] Message Index

[#] Next page