Vehicle & Technical > Series Land Rovers

Fairey freewheeling hubs?

(1/2) > >>

Ollie:
Hi,
How do you remove the fairey hubs from a SeriesIII :? I removed the small grub screw from the cap, but the think wouldn't budge :cry:
The wheel bearings have gone, (I think), in Lillie, and having no idea what they look like, or, what else might need replacing, I need to get this cap off!!

Is there a rebuilding kit available, with all the probable bits and bobs :?:

Cheers.
Ollie

muddyweb:
Undo the 6 bolts around the edge of the hub, these hold it to the axle.  With a little gentle encouragement it should come off.

Ollie:

--- Quote from: "muddyweb" ---Undo the 6 bolts around the edge of the hub, these hold it to the axle.  With a little gentle encouragement it should come off.
--- End quote ---


Tim,
I did this, until the nuts were hard up against the hub. There was a gap of about 6-7mm, and I could see behind the flange, but it was stuck there. Any further ideas :?:  :?:

Cheers.
Ollie

graham2306:
My freewheel hubs came off real easy, as explained above.  Have you got a pic of the hub?  Where are you If i'm passing I'll take a look.

graham2306:
Just occured to me, Lilly is a lightweight and has different hubs/ halfshafts to a normal series motor.   I read somewhere that you have to have different halfshafts to fit freewheel huns to a lightweight so maybe the hubs are different.

Navigation

[0] Message Index

[#] Next page