Chat & Social > The Bar - General Chat

External cages

(1/4) > >>

dave_2A_2.25Turbo:
I like the idea of an external cage for my Series, but would like to know where the front legs bolt to once they've passed through the wings.    I know the same applies for 90s/110s so it's here in the general section.

drmike:
I think the usual arrangement is to weld some big box section onto the chassis near to the outriggers and the downpipe lands onto that once again usually welded I think.

But no doubt someone with more experience will be along in a moment!

Mike

Xtremeteam:
you have to make outriggers for the cage the come down on to & on my racer its 4x4 4mm thick box i think,hit it with a hammer & it rings

landyman Ash:
Its usually a standard set of out riggers with the cage welded onto it.

Mine are standard out riggers BUT i want make some nice custom ones likes Mikees so they also ring

Mine go...dud.

I need stronger ones!!!! I may just plate mine all over, I may re-do them.  Not sure yet  :?

Tractorboy16:
hi,

this is a pic of a mates truck that has it come through the wing. The wing isn't here on this pic bt you can see the outrigger that the role cage goes onto with the piece of tube going up that at sloghtys onto.



me xxx

Navigation

[0] Message Index

[#] Next page