Vehicle & Technical > Discovery
Scorpion Winch Bumper fitting
gords:
--- Quote from: "beast5680" ---is it the steering guard thats too close to the chassis? maybe you could drill a hole where the plate needs to be then hacksaw down either side so you have a "U" shaped cutout to allow the bracket to be fitted
--- End quote ---
The bracket will slide into the gap (just, I think) but there's no room for the head of the bolt ... and no way to get it in there either :roll:
Now, you see, I was hoping to avoid the whole "hacksaw" thing 'cos it's just too blooming hard :wink: Surely somebody must have an electric powered, hand held thick panel cutting thing ... surely :? :wink:
beast5680:
you mean an angle grinder :lol: or a plasma cutter would be good but i dont have one of them
colintandy:
i had same problem and just drilled straight through 8mm galvanised steel plate treated hole with rust proof and a touch hammerite all is cool and i know it works cos all i did all day sunday on challenge was winch winch and more winching
colintandy:
get an angle grinder there so much fun!! dont you just love making sparks fly
gords:
--- Quote from: "colintandy" ---i had same problem and just drilled straight through 8mm galvanised steel plate treated hole with rust proof and a touch hammerite all is cool and i know it works cos all i did all day sunday on challenge was winch winch and more winching
--- End quote ---
Err, pardon? Do you have pictures?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version