Vehicle & Technical > Discovery
Building an off road Discovery! (now inc taking it apart!!)
Jake:
I've been fitting some new bits :D
Here's my QT 3 degree castor corrected radius arms
Here's my Devon 4x4 cranked trailing arms
This is my new battery :(biglove):
Its a Odyssey Extreme, as fitted to the Devon 4x4 challenge 90
Its a like a Optima red and yellow top in one.
These are my extended Goodrich stainless brakelines
And for those that did'nt see...
Here's my new Devon 4x4 front turrets and relocation cones
and my rear relocation cones (picture has the spring clamps on)
Lovely new toys
8)
Jake:
I forgot to post this before :roll:
This is my Discoparts rear bumper
and this is the cb aerial mounted on the Devon 4x4 spare wheel carrier
and this is my new Terrain Master Hi Lift carrier i brought form Turtle
8)
Littledan:
looking very good jake
keep up the good work!!!
dan
muddyweb:
Just a tip Jake....
The cones will work better if you fit them so that they are in-line with the vehicle... i.e front-back and side-side rather than on the diagonal that you have.
Jake:
--- Quote from: "muddyweb" ---Just a tip Jake....
The cones will work better if you fit them so that they are in-line with the vehicle... i.e front-back and side-side rather than on the diagonal that you have.
--- End quote ---
:roll: :roll: :roll:
It was still loose when the picture was taken
:roll: :roll: :roll:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version