Vehicle & Technical > Defender

HELP

<< < (2/4) > >>

timberdog:
i can see a spade connector on the oil feed bit on block which is next to the oil filter?

timberdog:
could you ring me on mobile :07707270979

timberdog:
Right i have had the lift pump off and manually pump the the Fuel from the fork which goes into the engine block and i can get fuel to the top of fuel filter bleed valve and i had pressure on the little handdle on the side of the lift pump you use to pump up fuel.

I checked the switch ( Now i found it ), and i left the ignition turned on and when i disconnected it and re connected it i heard ticking so i presume its working but it still wont turn over and no fuel comming out of the injectors when turned?

The only thing i can think of is i have got a Fuel pipe wrong?,

philbert:
is your lift pump actually lifting when the engine is turned over.disconnect the line between pump and filter and crank the engine over and see what happens.

timberdog:
I have tried manually pumping and their is pressure on the manual arm but no fuel comming out of the end of the fuel line to to the fuel filter ?, i can hear it pumping down the fuel pipe but no show with fuel its as if it has not got enough pull on the fuel?

Navigation

[0] Message Index

[#] Next page

[*] Previous page