Vehicle & Technical > Defender
Replacing prop UJ's - tips please
Kenny:
I magine it would be fairly easy if I COULD GET THE DAMN PROP OFF. Think I will have to get hold of the correct tool.
Damian
davidlandy:
use 2x 9/16 spanners
Kenny:
9/16 - Helps if you use the right spanner - I was using a 14mm and 15mm one.
OK Prop is now off. I have the Yoke in the vice and am using a 19mm socket and banging that. The bearing cup is not moving at all and nothing is protruding out of the other end.
Am I doing something wrong, is there a trick to this.
Damian
Sharpshooter:
Im assuming you have taken the circlips out...
davidlandy:
I always tap the cups in a little first just to loosen them from the circlips
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version