Vehicle & Technical > Discovery

Steering guard

<< < (3/6) > >>

Dave:
Just been making some alterations so i can get the front recovery points back on.

Dave:
Both of them.

TUFFTEE:
Ah! this is where i have problems! with the front A frame! i can't figure out where to put them yet!

barmiebrumie:
Dave, any chance of a picy of how it bolts at the back :?: , have got a very large bit of 10mm thick ali which is bent at one end so cut down would make a good guard, but unsure as how to fix it at the back & how low it should be,

thanks in advance  John.

Dave:
Nev, John hope this helps i made them out of 12mm steel make a cardboard templet first its a pain to grind. My dad got the most part done at work  :wink:

Navigation

[0] Message Index

[#] Next page

[*] Previous page