Vehicle & Technical > Discovery

small bit of boot welding needed......one day later.

<< < (2/2)

Matt_H:
lace work would be more appropriate for the back body cros member....

Anyway I managed to get one out (the one with the head intact) using the 3 foot hammer. The one on the other side (which didn't have a head on the bolt) has obviously allowed much more water in and was rusted fast. I started to drill it out and did quite well until I punctured the side of the tube - bugg3r!

So now I'm not sure what my options are- I guess the best bet would be to cut out the tube part and weld in a new one - I don't suppose you can buy them off the shelf can you?  Any other ideas?

ta
Matthew

Navigation

[0] Message Index

[*] Previous page