Chat & Social > The Bar - General Chat
Cutting up fiberglass sand ladders?
TimM:
You might want to have some thick gloves to hand in case of any bits flying off, and beware of the rough surfaces (for 'splinters')
Barry Scott:
I got some nice thick gloves with my Hi-lift recovery accessories, I'll use them.
barmiebrumie:
Barry, wear protective clothing ie:- gloves paper overalls & dust mask, small splinters will get into your skin & make you itch like mad, bin the overalls afterwards, i work for a lotus approved bodyshop so know what it s like,
hope this helps,
john.
Barry Scott:
Ta, I will find some old clothes to wear and bin after. I knew it was bad because someone had worked on it when my brother was at school and left the dust all over the work top. He spent a lesson leaning on it and it messed his arms up, rashes for ages.
Porny:
--- Quote ---Water, mask and googles it is then. Out comes the black and decker.
--- End quote ---
Mixing water and electricity.... sounds like the rash from the fibreglass will be the least of your worries :twisted: :wink:
Ian
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version