Vehicle & Technical > Defender

Oil Pressure Warning Light...

<< < (2/2)

Wanderer:
I've just seen the original post. It could be the oil pressure switch wire is chaffing somewhere and it's grounding it.

Fitting an oil pressure should just be a case of taking out the switch and replacing it with the guage adapter. Then put the switch back in and then pipe up the guage inside the motor.

Ed

landyman Ash:
Get a TIMS oil pressure guage.

Cost you about £30 and its a doddle to fit!  Screws straight inot a defender dash then the copper pipe runs down to the oil switch.  Take the switch out and screw in the copper adaptor then the pipe.  Will take you MAX 10 mins and give you a proper oil pressure reading!

Ive got one, never going back ever!  Ypu can get them on ebay or from vehicle wiring products or alot of good car auto part places

landyman Ash:
Looked on ebay, loads there juts make sure it comes with the copper pipe.

Heres the link to VWP

http://www.vehicle-wiring-products.co.uk/VWPweb2000/gauges/gauges.html

and then its the oil pressure gauge.  I had it on my V8 and now its on my 300tdi so its very universal and the best bit is there are no electrics except for illimainating the gauge!!!  Thats what I like!  :D

Landy90IOM:
looks like that will be the best idea... thanks for the help guys!

Navigation

[0] Message Index

[*] Previous page