Vehicle & Technical > Defender

Fitting a 300TDi to a 110 Chassis

(1/3) > >>

snezza69:
I have just bought a replacement 110 chassis which has engine mounts for 2.5 n/a Diesel.  I want to fit a 300TDi engine.  I have been told that the engine mounts can be fabricated with 2 inch angle iron.  Does anyone know the measurements to position these mounts and at what position they should be.  Pictures would be a great help.  I have been told that the best way is to fit gearbox to the crossmember and then position the engine to work out position however I am still waiting for a gearbox and the crossmember and the engine mounts need fixing soon so the chassis can get galvanised.

hobbit:
http://forums.mud-club.com/viewtopic.php?t=10089&start=30
See my posting there
something I mentioned the other day, his is an early ninety

snezza69:
I have just seen a kit by M+N engineering, I have tried to get their number off the yellow pages web site but they dont show up.  Does anyone have contact details for them?

Xtremeteam:
speak to landyman1978 as hes just fitted a 300 tdi into is 88/90 just recently using the M+N kit

landyman Ash:
The kit is actaully from M+D

Sorry, I some how put M+N on my posting!!!!  :oops:  :oops:

Motor & Diesel Engineering (Anglia) Ltd.
Rowan Farm, Priory Road, Ruskington, Sleaford, Lincs.
NG34 9DJ. United Kingdom.
Tel: 44 (0) 1526 830 185       Fax: 44 (0) 1526 830 217
Email :enquiries@mdengineering.co.uk

Is all their details

I think its a bit pricey but then again within 30mins I had cut the mounts off and welded on the new ones so on reflection the extra cost is a bargain!!!!

Navigation

[0] Message Index

[#] Next page