Vehicle & Technical > Series Land Rovers

1977(ish) SWB Series III - oil on brakes

(1/2) > >>

dapleb:
Hello,

I have LOTS of oil (not brake fluid) finding its way on to my OSF brake shoes, is this a common problem?

There is a small leak from the swivel pin housing but this doesn't look like the cause. Could it be the main axle casing oil seal that has given up? I'm sure the cause will become apparent with some digging, but would appreciate some advice.

Cheers
dapleb

muddyweb:
Sounds like the axle oil seal.

Make sure that when you do change it (it's not a terrible job) that you also check the axle breather (little bit screwed into the top) to see if it's blocked.  This is a common reason for the failure of the oil seals.

dapleb:
Thanks for the response and advice muddyweb much appreciated.

Cheers
dapleb

Frankie-Boy:
Make sure you jack the axle as high as possible when taking the hub and old seal apart, it helps keep in whatever oil is left in the axle, otherwise it'll end up on yer driveway.

Mostie:
Sounds like I have a similar problem on my 90. This is going to be next weekends job (replacing the seals and doing bearings at the same time), is there an idiot proof method of testing the breather pipes?

Also has anyone tried using those tubes of grease that go in the hubs instead of ep90? fancy I might give it a try because at least itll have less tndancy to leak if i dont get it right!

Navigation

[0] Message Index

[#] Next page