Vehicle & Technical > Discovery

300 to 200 rear lights

<< < (2/2)

hobbit:
As long as you have all the correct lighting items, the order does not matter, In the end I have indicators and fogs on the bumper, if I have the bumper under water then no power will be going through there unless I switch it on.

Tail, brake and indicators along with reverse lighting all run through the main clusters, along with a second tail light as well

Bush Tucker Man:
Mine simply exchanged as the required services were already at the plug (Check with a Multi-meter)

All I had to do was remove old, unplug  & replace with new.

If it's a 7-seater, it's far easier to remove the seats (TORX 30, or possibly, 35)

And it you tow, you'll need a replacement indicator relay, in order to cope with the extra demand & flash at the correct rate.
This will also activate the trailer tell-tale on the dash to indicate (pun intended) that the trailers indicators are functioning as legally required

AMR 4873 is the relay in question for a 30Tdi with 4 rear indicators (well, it was for mine)
It's dear!, about £25.00

Mark2Disco:
i all ready have towing gear and the higher rating flasher unit
but at the plug for the light unit there are connections missing from the plug
ie the indicator and tail light connections

ChrisW:
Mine were like that, I ended up putting some small crimp lugs on the ends of the extra cables I needed and giving them a helping hand to go in the multiway connector  :wink:

Where abouts in Brum are you, seeing as I have done this mod once already  :wink:  also off work this week  :wink:  :wink:

Mark2Disco:
im in northfield
but i havent got off side lamp yet only nearside thanks anyway

Navigation

[0] Message Index

[*] Previous page