Vehicle & Technical > Discovery

ABS Blankers for axles??

(1/3) > >>

landyman Ash:
Ive just bought a set of axles for a disco and the front have the ABS sensors removed.

Thats fine as I dont want them BUT there is now like a hole (looks like the king pin is missing buts not) so can you get something to block these ABS sensor holes?  

If not I'll metal putty them or make a plate and silicone it down but was looking for the easiest option!

gords:
Why do you need to blank/fill them? (asking, not arguing :wink: )

landyman Ash:
They are going on the hybrid and when you look into hole, it goes into the internals of the swivel.  When I go into water and mud they will fill up and it will be new swivel time.....

And I hate doing swivels!

Just want to stop the water and mud getting into them

gords:

--- Quote from: "landyman1978" ---They are going on the hybrid and when you look into hole, it goes into the internals of the swivel.
--- End quote ---

How weird!

Could you not put a bolt through with a bit of instant gasket on the washers?

landyman Ash:
Very weird!!

I thought when I picked the axle up the king pins were missing!!  

The holes are quick large so I think a plate or a bit of metal putty might just be easier.

Pain in the bum  :evil:

Navigation

[0] Message Index

[#] Next page