Vehicle & Technical > Series Land Rovers

Series 3 rebuild

<< < (2/6) > >>

robbie:
I was meaning the rear of the door along the bottom edge. This gap should be pretty even along its length. If it isnt, then it would suggest the bulkhead may not be square

Andy the Landy:

--- Quote from: "robbie" ---I was meaning the rear of the door along the bottom edge. This gap should be pretty even along its length. If it isnt, then it would suggest the bulkhead may not be square
--- End quote ---
Ahhhhhhh - didnt check that - just saw the overlap at the top and concentrated on that, will have a look tomorrow :D

robbie:
lets hope it is that simple :) If it is,then I would guess the bulkhead needs straightening a little. (or the floor needs bending back - sorry, being silly now, go for the bulkhead option :) )

robbie:
I am assuming the gap between the door and bulkhead/windscreen is about the same from top to bottom?? This again would indicate bulkhead not square

Andy the Landy:
Think its the top of the bulkhead that may need to come forward and the bottom stay where it is - if that makes sense :?

Navigation

[0] Message Index

[#] Next page

[*] Previous page