Vehicle & Technical > Range Rover

Axle change on my Rangie Classic...

<< < (2/2)

Xtremeteam:
all motors up to around 93/94 had 10 spline coarse shafts.from 94 onwards they went to the fine spline shafts n diffs,these are the 24 spline that you are refering to,if you fit a fine spline set up,make sure its the whole thing not mixed & matched as there is all sorts of differences that make problems if they arent adressed when building it

landyman Ash:
I run 10 spline but my ARB locker is 24 for the same reason as you, Ive been told they are stronger.

However its far easier changing a broken half shaft than a samshed diff or worse a gear box.

Im going to try the 24 and see what happens, so at this moment I would say go 24.

Also bear in mind the 24 shafts are harder to get and more expensive, ive bought a few sets off ebay as when you run ARB and simex......

........expect to break ALOT of shafts!!!!!!

Navigation

[0] Message Index

[*] Previous page