Vehicle & Technical > Discovery

You're gonna love this clutch story

<< < (2/5) > >>

muddyweb:

--- Quote from: "Digsit" ---Pivot link thing? :-k
--- End quote ---


The operating arm for the clutch.   It sits on a pivot in the bellhousing, it should be fixed with a clip.

There is also a little plastic clip which attaches the slave cylinder pushrod to the end of the clutch operating arm.

Digsit:
Ah ok :D

The operating arm should'nt fall off tho, should it :shock:

The plastic clip that holds the pushrod against the arm was found to be broken when I did my slave cylinder. Was assured that it would be fine without it............

And those assurances were correct :D Been fine ever since :roll:

muddyweb:

--- Quote from: "Digsit" ---The operating arm should'nt fall off tho, should it :shock:
--- End quote ---


Nothing *should* fall off ;-)


--- Quote from: "Digsit" ---And those assurances were correct :D Been fine ever since :roll:
--- End quote ---


You just know you are going to regret saying that, don't you.

gords:

--- Quote from: "muddyweb" ---
--- Quote from: "Digsit" ---And those assurances were correct :D Been fine ever since :roll:
--- End quote ---


You just know you are going to regret saying that, don't you.
--- End quote ---

tick, tick, tick ...  :wink:  :lol:

Digsit:
Surely if it was gonna be a problem it would have failed by now :?

Navigation

[0] Message Index

[#] Next page

[*] Previous page