Vehicle & Technical > Discovery

200tdi inner sills and the MoT

<< < (2/3) > >>

Xtremeteam:
the sills are structural & are a pain to do,just doin a pair on a v8 h plate disco jus now,only got the front inner wing to go & its finished,glad of that as its been gettin worked on since jan

Wanderer:
Welding upside down isn't too bad until one of the sparks goes down into your ear. You do a very strange dance and swear loudly.
 :lol:  :lol:

Ed

denviks:
i am new to  this welding lark.....believe it or not i have learnt this strange dance in only a few minutes of starting.  :shock: ....you pick it up very fast. just got my back floor and rear body crossmember to do now so plenty more practice doing the dance im sure.  :lol:  :lol:
just bite the bullet and do the welding...... :wink:

hobbit:
Best thing is to go back as far as you can so there is good clean metal, not good clean wafer thin metal to weld to

Always good for a laugh, especially when the bits fall down your sleeve, boot or trainer, and the crackling noise in your tab of cooking way :wink:

and the dance of trying to get your hand down your shirt and ripping it open

Wanderer:
:lol:
It's amazing how they can get inside your boots.

A couple of old mattresses do the trick on something like an old Panda or Suzuki. More difficult on a Disco though.

Ed

Navigation

[0] Message Index

[#] Next page

[*] Previous page