Pages: [1]   Go Down

AuthorTopic: abs panels  (Read 1572 times)

0 Members and 1 Guest are viewing this topic.

Offline lambert

  • Moderator
  • ***
  • Posts: 2137
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • and then as if by magic
    • harrogate
  • Referrals: 0
abs panels
« on: May 19, 2012, 10:15:04 »
Been on eBay looking for a new wing and for a cost I can get an abs one. How would I get on making the whole body from abs assuming I could get a plastic welder and fab up the bits would it be strong enough?
Logged
Lambert Coverdale.

As slow as possible, as fast as necessary.

Two and a half litres of turbocharged diesel goodness.

Offline Saffy

  • Posts: 3127
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
    • The Bell Inn, Imber.
  • Referrals: 0
Re: abs panels
« Reply #1 on: May 19, 2012, 13:25:50 »
barbie and action-man seem to get on fine with theirs - not sure what's wrong with the body you got though - take some pic in front of mirror and let us judge.

i'd worry that the fact ABS has a mere fraction of the life of an alloy panel due to being very prone to UV decay. I dunno, maybe nto a factor if it cheap and easy to replace.
« Last Edit: May 19, 2012, 13:29:28 by Saffy »
Logged
.swonk eno oN .esoht dna eseht ,siht dna taht ,wollof ot selur emos teg eW

Offline lambert

  • Moderator
  • ***
  • Posts: 2137
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • and then as if by magic
    • harrogate
  • Referrals: 0
Re: abs panels
« Reply #2 on: May 19, 2012, 14:12:16 »
haddnt thought about uv decay, pitty. oh well next clever idea.
Logged
Lambert Coverdale.

As slow as possible, as fast as necessary.

Two and a half litres of turbocharged diesel goodness.
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal