AuthorTopic: Any ideas  (Read 4676 times)

0 Members and 1 Guest are viewing this topic.

Offline gtomo2

  • Posts: 1924
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Any ideas
« on: March 17, 2012, 21:53:56 »
Mate got a 4.0 ltr v8 rangie p38 had a flat battery charged it up started the rangie up and revs went stright to red line Switch it off tryed it again and it went to the red line again. After a look under the bonnet found the rubber pipes going from the plastic bulb to the maf? had perised refitted them but now it wont start also the windows now don't work also there is no display for the heater. So me thinking ecu anybody else have any ideas also anyway to reset the ecu's without softwere eg pulling fuses.
Thanks
Mr Graeme Thomas (tomo)
300 TDi Discovery - So i can go fording
Stop laughing put the camera down AND PASS ME THE TOW ROPE !! PLEASE

Offline piggysteve

  • Posts: 523
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: Any ideas
« Reply #1 on: March 18, 2012, 09:08:43 »
They can do all sorts of funny things after a flat battery, is it turning over, if so what does the display say. The message display should tell you of fuse failure, it might be worth checking the fuse box in the engine bay for damage they are prone to failure.

Steve
Ex pat Yorkshireman.

P38 diesel

Offline gtomo2

  • Posts: 1924
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: Any ideas
« Reply #2 on: March 23, 2012, 20:01:59 »
That would be part of the problem no disply of anysort. Will check the fuses.
Mr Graeme Thomas (tomo)
300 TDi Discovery - So i can go fording
Stop laughing put the camera down AND PASS ME THE TOW ROPE !! PLEASE

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal