AuthorTopic: wheel studs question  (Read 1334 times)

0 Members and 1 Guest are viewing this topic.

Offline brixworth-alan

  • Posts: 162
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • The new acquisition
  • Referrals: 0
wheel studs question
« on: September 19, 2010, 09:17:27 »
OK, so I ordered some replacement wheel studs from Paddocks and what do u know they're the wrong sort, as I need the screw in type not the push in type (doh). Before I go and order them from LR series though, is there just one type or did they vary as well? LR series part says 'series 1, 2 and very early 2as'- mine is a '66 plater so not very early.

Can anyone advise? cheers Alan

Offline bogie

  • Posts: 695
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • IF IT AINT GOT LEAFS,ITS NO GOOD!!!!!!!!
  • Referrals: 0
Re: wheel studs question
« Reply #1 on: September 20, 2010, 20:20:20 »
Hi mate,the early studs were 9/16 and the s3 were 16mm.The early 9/16 were screw in and the later were push in from the back.All the bearing carriers are interchangable if that helps.
1968 SERIES 2A ,200TDI TUNED,RANGE ROVER AXLES,ONE TON SHACKLES,CPC PARAS,ES3000,POLYBUSHED,ANACONDAS.                     1970 SERIES 2A, 200TDI TUNED,5 SPEED LT77 WITH LT230S TRANSFER BOX 1.211 RATIO.ZEUS DISKS ALLROUND.ES3000,MODIFIED 90 TANK,3.5 DIFFS.

Offline brixworth-alan

  • Posts: 162
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • The new acquisition
  • Referrals: 0
Re: wheel studs question
« Reply #2 on: September 21, 2010, 22:06:28 »
Cheers- looks like I got early carriers on a later car then :)

Hey- ever find that axle case?

Thanks!

Alan

Offline bobtailed disco

  • Posts: 452
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: wheel studs question
« Reply #3 on: September 29, 2010, 10:27:11 »
i replaced mine with the push in ones (were thredded) just drilled the hub out

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal