AuthorTopic: 300tdi into series  (Read 4684 times)

0 Members and 1 Guest are viewing this topic.

Offline dead camel

  • Posts: 43
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • my landy
  • Referrals: 0
300tdi into series
« on: September 11, 2009, 13:35:45 »
i am contemplating putting a 300 tdi disco engine into my lightweight 2 1/4 petrol, anyone know of any conversion kits or how easy to change gearbox  etc, any thoughts greatly appreciated.
4 kids one wife!!

Offline twiggy

  • Posts: 8
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 300tdi into series
« Reply #1 on: September 11, 2009, 21:58:04 »
Hi I'm no expert but the 200tdi is muuuuuch easier to change over, a lot less hassle ( I believe the mountings for the 200 are the same as the 2.25 petrol). I looked into changing my 109 petrol and the 200 tdi came up trumps. I even got the donor disco but found a 109 diesel before the spanners came out.

Offline stuntman

  • Posts: 693
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 300tdi into series
« Reply #2 on: September 14, 2009, 12:31:15 »
You'll need to chop the mounts off the lightweight chassis and weld the engine mounts from the disco on, other than that, it's an easy swap.

Use the 2.25 box, fab up an exhaust and you're away :)

electrically, as easy as a 200 to wire in.
1989 3.5slti Mazda powered 110DC

Erm ... I've lost my keys darling ... again!

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 300tdi into series
« Reply #3 on: September 15, 2009, 18:20:55 »
200 or 300 its not too complicated but its very time consuming! www.lightweightlandroverclub.org may have some1 whos put the 300 in.
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

Offline dead camel

  • Posts: 43
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • my landy
  • Referrals: 0
Re: 300tdi into series
« Reply #4 on: September 16, 2009, 13:39:37 »
fantastic stuff thanks guys, a bit more contemplating to be done (and pursuasion to the wife!!) thanks again. so the series box will fit to engine block ok?
4 kids one wife!!

Offline tuko

  • Posts: 5
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 300tdi into series
« Reply #5 on: September 17, 2009, 19:33:25 »
fantastic stuff thanks guys, a bit more contemplating to be done (and pursuasion to the wife!!) thanks again. so the series box will fit to engine block ok?
Yes it will with some work.
I have a 300Di in my 88'' hybrid.
Todd.

Offline p4203

  • Posts: 182
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 300tdi into series
« Reply #6 on: September 22, 2009, 18:04:41 »
i am also putting a 300tdi into my s11 later this year when the rrc gets finished got all the bits just need the time :grin:
s111 109" 24volt 3.3 perkins  "beasty" 1975
300tdi disco safari  1999
2door rr 3.5 efi 1979 "shed"
1961 s11 swb soon to be 300tdi'ed

Offline andyb

  • Posts: 412
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Tilshead, Wiltshire
  • Referrals: 0
Re: 300tdi into series
« Reply #7 on: October 06, 2009, 12:07:06 »
Only the Discovery 300 Tdi will bolt straight up to a Series box (altho you have to redrilll a couple of holes IIRC).

The 300 does also have the advantage of a higher mounted turbo that over comes some of the problems of fitting a 200 into a Series.

Offline bogie

  • Posts: 695
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • IF IT AINT GOT LEAFS,ITS NO GOOD!!!!!!!!
  • Referrals: 0
Re: 300tdi into series
« Reply #8 on: October 06, 2009, 20:20:33 »
Disco 200s fit perfectly in to a series.Much better engine than a 300.
1968 SERIES 2A ,200TDI TUNED,RANGE ROVER AXLES,ONE TON SHACKLES,CPC PARAS,ES3000,POLYBUSHED,ANACONDAS.                     1970 SERIES 2A, 200TDI TUNED,5 SPEED LT77 WITH LT230S TRANSFER BOX 1.211 RATIO.ZEUS DISKS ALLROUND.ES3000,MODIFIED 90 TANK,3.5 DIFFS.

Offline tuko

  • Posts: 5
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 300tdi into series
« Reply #9 on: October 16, 2009, 21:40:39 »
Only the Discovery 300 Tdi will bolt straight up to a Series box (altho you have to redrilll a couple of holes IIRC).

The 300 does also have the advantage of a higher mounted turbo that over comes some of the problems of fitting a 200 into a Series.
A Defender 300tdi WILL bolt up to a series transmission.
My 300Di motor is from a 1997 Defender.
Todd.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal