Pages: [1]   Go Down

AuthorTopic: fitting a stepper motor  (Read 337 times)

0 Members and 1 Guest are viewing this topic.

Offline burgerman

  • Posts: 1027
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 1
fitting a stepper motor
« on: August 05, 2008, 23:18:04 »
 Any tricks to fitting a "new" stepper motor to a 1991 V8 3.5 disco ? ?      Is it just a case of unplugging/unbolting old one and replacing? OR do i need to set up/reset/adjust the new item ??   Any tips welcomed :lol:
Logged
TD5 with a few Tweaks ;o)
a bit more fuel friendly than the V8

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Re: fitting a stepper motor
« Reply #1 on: August 06, 2008, 03:15:02 »
I always juts stick them in.  The ECU should callibrate the stepper every time the engine starts.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal