Pages: [1]   Go Down

AuthorTopic: lambard senser  (Read 337 times)

0 Members and 1 Guest are viewing this topic.

Offline gtomo2

  • Posts: 1924
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
lambard senser
« on: August 05, 2008, 15:37:14 »
right i am fitting new y section to my exhurst system and it has got a lambard senser near were the middle box joins the downpipes. but i dont have cats on this disco so wondering if it was for the lpg if so can anybody please tell me the normal resistains on the two sets of connections as the new exhurst does not have the hole if the senser to fit in plus there is no way the old senser is going to come out of the old pipe. Its a 3.5 efi v8 1991 with lpg. thanks
Logged
Mr Graeme Thomas (tomo)
300 TDi Discovery - So i can go fording
Stop laughing put the camera down AND PASS ME THE TOW ROPE !! PLEASE

mentalmoshio sophs V8i

  • Guest
Re: lambard senser
« Reply #1 on: August 05, 2008, 19:03:07 »
 :| any chance of a pic m8 im kinda lost on where ur new sensor needs to be
Logged

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Re: lambard senser
« Reply #2 on: August 06, 2008, 03:20:20 »
If it's needed for the LPG then you'd better put it back, otherwise it just won't work.  You can buy new bosses to weld in to the exhaust.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal