Pages: [1]   Go Down

AuthorTopic: rusty rear bumper  (Read 1053 times)

0 Members and 1 Guest are viewing this topic.

Offline 110landy

  • Posts: 7
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
rusty rear bumper
« on: July 03, 2008, 15:31:30 »
hello there
my 110 has bad rust problems and i need some advice,
the other day i was jacking the rear drivers side when the bumper started to crumble :'( i need to know if it is possible to replace this or do i need to start looking for a new chassis, the chassis i perfect no rust and is very clean just the rear :?
Logged
Liam

Offline Jimbo

  • Posts: 1126
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: rusty rear bumper
« Reply #1 on: July 03, 2008, 16:12:55 »
When you say bumper - do you mean the rear crossmember, the black/rusty coloured lump of steel that runs the full width of the rear of the vehicle ?

If it is, then the simple answer is yes - you can get a new one, it's not a bolt on job, the old one needs cutting off, and the new one needs to be properly welded on.
Logged
Jim

TDV6 HSE D3
Defender 110 Td5 Hard top, BFG MT's, and no EGR either

http://www.hertfordshire4x4response.net

Offline 110landy

  • Posts: 7
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: rusty rear bumper
« Reply #2 on: July 03, 2008, 16:42:13 »
yes thats what i mean ;)
im new too landys so still learning
thank you for the hep
Logged
Liam

Offline Les Henson

  • Posts: 369
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Is it supposed to do that?
  • Referrals: 0
Re: rusty rear bumper
« Reply #3 on: July 04, 2008, 05:12:00 »
You can repair the crossmember if it's not too bad, but judging from what you say - it needs replacing.
What you are letting yourself in for :)

http://forums.lr4x4.com/index.php?showtopic=24885


Les.
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal