AuthorTopic: speaker wiring and amp fitting  (Read 343 times)

0 Members and 1 Guest are viewing this topic.

mentalmoshio sophs V8i

  • Guest
speaker wiring and amp fitting
« on: May 05, 2008, 11:33:01 »
ive got infinity 6x9 and a 2 channel 400w amp  where do u run the wiring through in the cab mounted it on a parcel shelf.

can u piggyback stero output wire on the front to get 2 in the front doors on either side.

same question apply for the amp looking at a pair 6 1/2 pioneer for on the parcel shelf to.

as for a protection from on lookers i plan to use an es load linear over the top to hide ever thing
« Last Edit: May 05, 2008, 11:37:14 by david p »

Offline Jake

  • Regional Rep
  • *
  • Posts: 5474
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • <insert witty comment here>
    • South Molton, Devon. UK
  • Referrals: 0
Re: speaker wiring and amp fitting
« Reply #1 on: May 05, 2008, 13:26:26 »
When i ran my wiring for my amp the battery live i ran down the chassis and into the boot via the rubber grommits that were for the tow electrics
The phono jack leads and radio live i ran down the dash, under the kick plates at the bottoms of the doors (you have to lift them out and feed the wire under the carpet) and then under the brear seat carpet to the boot.
You can piggy back speaker wiring, just make sure your using suitable cable
I've since turned the boot live into a fuse box and run the amp, power outlet (for fridge) and 2nd battery controlled caravan electrics from one handy location

 :D
Jake

Owner - Land Rover Discovery 2
Driver - Land Rover Defender 100" Trayback

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal