AuthorTopic: 200TDi in me lightweight, update on build! :)  (Read 17086 times)

0 Members and 1 Guest are viewing this topic.

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #30 on: July 04, 2008, 19:33:56 »
update: getting it done slowly when i get time to work on her! really wish i was doing this inside! rad and intercooler in and plumbed up-just about!, not totally secured yet.
lots of joining pipes n its all a very tight fit, next up finish the fuel lines and go for a start up! few pics...( notice the ends of the intercooler iv cut back an inch ish and then reground a lip for a good fit - gains that lil more room-soo many jobs like that on this build.) also iv fitted the top part of the thermostat from my series engine so water exits upwards so doesn't get in the way of air inlet.
Thanks for reading!
« Last Edit: July 04, 2008, 19:39:48 by lightweight-love »
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #31 on: July 04, 2008, 19:51:15 »
how to get the gearbox out of disco!
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

Offline Bowie

  • Posts: 204
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #32 on: July 05, 2008, 23:20:14 »
I hope to hell you didn't get underneath it like that!  :shock:
1980 SIII Lightweight 2.25 Petrol - completely standard.
1991 Range Rover Vogue SE 3.9 V8 - now on LPG (sorted!), 2" lift, mud tyres, and more to come...

Offline Jim-Willy

  • Regional Rep
  • *
  • Posts: 2750
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #33 on: July 06, 2008, 01:14:59 »
Are you insane?  I ain't a fan of H&S missen but thats flaming ridiculous......
'ear all, see all, say nawt; Eyt all, sup all pay nawt; An' if ivver tha does owt fer nawt; Allus do it fer thi sen.

     

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #34 on: July 07, 2008, 19:41:33 »
SHE RUNS!!!!!!
get turbo pipes done n throttle and im a rolling!
WOOO!!!!!
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

Offline baron von ledwidge

  • Posts: 143
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #35 on: July 07, 2008, 20:27:46 »
Just out of interest what did you do about running wires to the starter solenioid
Its just im thining of putting a tdi in my landy and trying ot get my head around it
aaron
Series iii 88"                Series 3 88"
2.25 diesel                  200tdi
 Hard top                     Exmoor Trim hood
checker plate wings     checker plate wings
checker plate sills        parabolic springs
checker plate floor       overdrive
                                    roll cage
                                    corabreu bucket seats   
                                    fairey overdrive
drive it break it fix it

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #36 on: July 07, 2008, 21:52:14 »
disco starter motor has solenoid on it so im gonna use that one, u could by-pass it and use the existing series 1 if u wanted. yeh lots of bits to get your head around but wiring isnt one of them! just fuel cut off and starter motor! love it!
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

Offline Devon-Rover

  • Posts: 748
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Tavistock
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #37 on: July 07, 2008, 22:44:13 »
most use the disco solenoid on the starter, just extend the red and white trigger wire down to it.

The stop solenoid just use the white feed that used to go to the Coil.
Rowan.

"Jemima" 2.25 Petrol SWB, ACR rear Silencer, 235/85 Macho's, MAP Capstan & HD Bumper, Tweeked suspension, CB, Light Bar.
"Baker" 2.6 Petrol LWB (former Tow Truck)
"Lizi" 4.2 V8i Discovery, Gone but not forgotten.
"Kate" 1985 Ninety 4.2 V8 Auto, Stainless exhaust, Ashcroft Tunnel, Mud console, Polmar Venus CB, HD Steering bars, Terrafirma Steering damper, D44 Winch Bumper, Superwinch EP9.5, Superwinch Wireless controls, QT Diff Guards. 'More toys to come'


Vorsprung Duch Ducktape. My website Searle Safari Info source.

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #38 on: August 09, 2008, 23:12:57 »
everything is now finished wid engine change! drives well and will plod along happily being as economic as possible, but then u can give it some gas and it can shift! is a great feeling accelerating like that in a series!
gearbox-wise it feels fine and i think driven respectably will be ok! 'but' if it does go and i decide to go for a different box whats the best alternative then? an R380?
couple pics showing the lowest point of exhaust(all made from disco bits!) is higher than x-member and behind shackles so is fine like that,
and iv used a 300tdi airbox and fitted the rocker breather into it!
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #39 on: August 09, 2008, 23:13:59 »
pic 2
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

Offline ian_s

  • Posts: 969
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #40 on: August 10, 2008, 12:06:45 »
i see you've gone for a slightly less subtle approach for the exhaust than i did :)
series 3 - 200tdi
Discovery V8

Offline lightweight-love

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200TDi in me lightweight, update on build! :)
« Reply #41 on: August 10, 2008, 23:37:15 »
yeah i decided its wat i wanted to do- fiddly making it tho! it just about has room to follow the same route as a 2.25 system, snazzy ending tho!
many thanks for answering some of my many questions along the way. :lol:
1975 s111 lightweight 200tdi, paras, snorkel, winch... My everyday ride
1976 s111 lightweight stock new restoration project :)
1974 s111 Long term restoration project, galv chassis, paras...
"she's not leaking oil, she's marking her territory"

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal