Anyone done the above - and if so what lessons did you learn and how would you do it again?
I am using US Class III receivers at both end, with the winch on a removable mount, I intend to wire the solenoid in and fix it to the mount (any recommendations on a waterpoof box - Maplin seemed to be a good starting point??), then only having a anderson type plug to attach to the vehicle.
So I think I need a run of 35mm sq welding cable from the front to the back with an anderson receiver on the end - where do I put it? do I waterproof it?
At the front I thought of dropping a very short cable out through the grill and again putting a waterproof cap on it again?
Inside the engine bay - going for dual batteries - (any pics of mounting second one in a Disco 1 appreciated), with a split charge system, and then wiring the winch direct (with a cut out) to the auxiliary battery.
What have I missed?
Any pics or descriptions of where to mount rear cables appreciated, and I was intending to tie wrap it to the inside of chassis structure?
Where's the cheapest place to get welding cable and anderson connectors?
Thanks in advance