AuthorTopic: Britax amber flashing light  (Read 1116 times)

0 Members and 1 Guest are viewing this topic.

Offline 3laner

  • Posts: 325
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Britax amber flashing light
« on: November 07, 2007, 14:55:33 »
Got myself a bolt on britax amber light for the roof.
Want to put it toward the rear of the roof,has anyone else got one?
wheres the best place to route the wires to get power and then to the switch?will i need to remove most of the headling and dash to get it looking neat?


Alex
1994 300 tdi Defender-SOLD
2002 TD5 Defender 90 Monte Carlo Blue: IRB stage 2 tuned and intercooled-SOLD
2005 Golf GTi 200- Landyless :(

ON THE LOOK OUT FOR MY NEXT 4x4
www.irbdevelopments.com

Offline 3laner

  • Posts: 325
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Britax amber flashing light
« Reply #1 on: November 07, 2007, 21:06:42 »
just realised i need to remove the rear headlining to bolt it on.how do i get it off is it just a case of pulling it?
1994 300 tdi Defender-SOLD
2002 TD5 Defender 90 Monte Carlo Blue: IRB stage 2 tuned and intercooled-SOLD
2005 Golf GTi 200- Landyless :(

ON THE LOOK OUT FOR MY NEXT 4x4
www.irbdevelopments.com

Offline MY90 MY LIFE

  • Posts: 40
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Britax amber flashing light
« Reply #2 on: November 07, 2007, 22:20:32 »
you need a plastic pin puller. looks like the claw off a hammer but flat so like a Y shape get some new plastic pins cuz some will snap. run all wires in the inner roof gulley or tap them to the roof using gaffer. id go via a fuse, but  straight from your battery via a switch on ya bulkhead so you dont need to worry bout routing up near your dash. hope it helps earth through one of your fixing bolts or one of the bolts that hold the roof on

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal