AuthorTopic: Ground Anchor  (Read 2497 times)

0 Members and 1 Guest are viewing this topic.

Offline wizard

  • Posts: 1095
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Cardiff. In the land of our fathers, so i am told
  • Referrals: 0
Ground Anchor
« on: January 02, 2005, 14:43:05 »
This Wizardbilt Ground Anchor is similar to the Pul Pal in design.It is however slightly smaller to allow for easy storage and transportation.

The tubular frame is made from 50mm x 25mm x 3mm box section. It has a shackle point at the front to attach a winch cable to and another at the rear above the spade to assist in pulling the anchor out of the ground.

The spade section is 300mm x 350mm x10mm steel plate and has three locating positions depending on the terrain it is being used in.

A vertical position for sandy terrain, a horizontal position for use in rocky areas and a central position for general soft / boggy mud





The Wizardbilt Ground Anchor has been coated with hard wearing black temachlor, a rubber/plastic like paint.

The frame and spade are bolted together with two M12 countersunk stainless steel allen cap bolts.



£100 plus postage or collect.
The ground anchor weighs 23Kg so postage will be expensive.

regards
wizard

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal