AuthorTopic: Ballast resistor?  (Read 767 times)

0 Members and 1 Guest are viewing this topic.

Offline dave_2A_2.25Turbo

  • Posts: 811
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Ballast resistor?
« on: August 01, 2007, 22:22:08 »
In conversation a few minutes ago, I was told that my 2A (with Ducellier dizzy) should have a Ballast resistor fitted.  Is this correct?  Where would it normally be locasted?
Dave
1963 S2A
1992 Disco 200TDi
Sankey Widetrack

Offline tomarse

  • Posts: 260
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Ballast resistor?
« Reply #1 on: August 02, 2007, 18:40:50 »
its the type of coiol you have fitted that defines wether you should have a ballast resistor or not.
You probably should if you have the proper coil in.

Offline James.Harwood

  • Posts: 303
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Ballast resistor?
« Reply #2 on: August 02, 2007, 19:46:58 »
If memory serves me correctly the balast resistor was used with 9 volt coils to keep the voltage to 9 volts to the coil when the engine was running, when you start it up it would bypass the resistor to up the power to the coil - better spark.

Never seen one on a Land Rover though (it may be there if I looked)

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal