AuthorTopic: Tappet like noise but tappets are fine  (Read 1333 times)

0 Members and 1 Guest are viewing this topic.

Offline madmike

  • Posts: 2
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Tappet like noise but tappets are fine
« on: June 12, 2007, 18:31:00 »
Hi all,

Wounder if anyone can help me, since having the engine rebuilt, i have had a tappet type noise coming from the engine in my 2.7td terrano. I have set and reset and re-checked the tappets and rockers, but all ok. I have fetch the head back off and found that three out the four combustion chambers (swirl pots - what ever they are called) in the head to be cracked although they do not seem to be loose. Could this be causing the noise?

With having the head reconned i have checked that the pistons do not protrude more than the head gasket, did a compression test before taken head off and have found the compression to be low (300psi), despite new rings and rehoned bores.

I have heard that little end bearings are common to go, just woundered if thats true and could that cause a tappet like noise?


Any help would be greatly appreciated as i am close to ring the scrap man. :(

mike

Offline trottster

  • Posts: 7
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: Tappet like noise but tappets are fine
« Reply #1 on: March 24, 2008, 20:13:16 »
ok to have small heat cracks in swirl chambers as long as they dont protrude into the cylinder head.
are you adjusting the tappets correctly ? what about the valves are they ok ?

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal