AuthorTopic: Starter Motor and Ring  (Read 1490 times)

0 Members and 1 Guest are viewing this topic.

Offline dmcgoo

  • Posts: 3
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Starter Motor and Ring
« on: November 28, 2005, 17:57:32 »
How long should it take a Land Rover dealership to change a starter motor and ring on a MK2 Freelander?  My local dealership have had my Freelander for over a week now after it failed to start, only had it for a few weeks !  I wouldn't mind but every time I call them they tell me should be ready tomorrow!

Miffed

Dave

Offline muddyweb

  • Posts: 6382
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Starter Motor and Ring
« Reply #1 on: November 28, 2005, 18:32:45 »
The actual job (I would guess) shouldn't be more than a day.. a lot depends on the availability of parts though..  A starter should be easy enough, but the ring might be a special order part, and that might be causing the delay.

They ought to be at least telling you what is going on though  :?
Tim Burt
Muddyweb
-------------------------------------------------------------------------------------------------------------------
www.muddyweb.com
-------------------------------------------------------------------------------------------------------------------

Offline Xtremeteam

  • Regional Rep
  • *
  • Posts: 6476
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Its just the way i roll
    • lampeter, west wales
  • Referrals: 0
Starter Motor and Ring
« Reply #2 on: November 28, 2005, 19:26:36 »
the starter takes about 45 min start to finiish but to take the gearbox out is a 7 hour job each way  :wink:
Mike
I can Drive.. You can criticize..
I too can criticize like you.. but can you Drive like me??


Offline dmcgoo

  • Posts: 3
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Starter Motor and Ring
« Reply #3 on: November 29, 2005, 19:51:26 »
Finally got it back today, but now when I go into reverse (its an auto) then back into Drive the display flashes between F and 4 and the Yellow HDC light is on.  If I turn the ignition off and on again it clears this fault and drives ok!

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal